Installing Sole Protector Plus+ Without Heat

In this video, we are going to focus on three simple steps for installing Sole Protector Plus+™ without heat – the 2017 Air Jordan [12] XII “Playoff” Low(s)..

Please note: For more complex soles with toe boxed patterns and deep groves, use the “SP Install With Heat” video.  These models include the Air Jordan 1, Air Jordan 3, Air Jordan 4, and Air Force 1s.

The three steps involved in the process are:

1: Aligning the material

2: Molding the material

3: Inspecting and securing the material


For prep you simply want to do a few things:

Clean the sole with warm water and soap or you can use a shoe cleaner that you trust.
Wipe the sole dry – the cleaner and drier the surface the better SP Plus+ will stick..
Have your SP Plus+ ready..
Find a good place to do the install – even, flat surfaces work well..
Set the shoe firmly in place to minimize unnecessary movements..


It’s really as easy as 1-2-3 on soles that have simple and straightforward designs..

Take your time and pick up the material from both ends and place it on the shoe.
Once you have it set – press firmly and mold the material into the grooves and sides.
Inspect and make sure all the material is secure against the sole. Go around the edges a final time to make sure they are sealed around the entire sole.
Check out your results..

Things to remember

The material will be sticky but don’t be afraid to reposition it to your liking…
There’s no need to rush – worse case just start over, the glue isn’t going anywhere
If the material is a bit stiffer than you would like – a little heat will help.. Please refer to our “Working With SP Plus+ And Heat” guide for more instructions..


We rely on your feedback so please let us know what we can do to help..

Thanks for watching and #KeepYourSoleClean…

Questions? You can reach us here: Contact Us


Do You Need To Protect Another Pair?

Visit The Sole Protector™ Store To SHOP NOW And #KEEPYOURSOLECLEAN